Probably a faulty potentiometer. It keeps kicking itself out of a routine. Ill probably pull it off tomorrow and work on the code, give it a hard start to force it to stay in the run mode. If it keeps messing up then ill have to look at the 12v power source. Something is acting a little bit wonky.
I Think the issue was from the draw of the 1Power 600w system pulling enough power to drop the voltage across the BCM’s brain, which would kick it out of its routine and put it in standby. I altered the code to keep it running when activated, and the iPower 600w system is not longer connected and everything is running fine.